20
Apr
2020
In Videos
VIS Concrete Design Program – Ouput
While the result of all engineering work is the final object (or structure) being built, what really comes out of an engineering office are documents: Calculation Reports, Drawings and
CSI ITALIA SRL
Galleria San Marco 4
33170 Pordenone
Italy
Telefono +39 0434 28465
Fax + 39 0434 28466
Toll Free
1-800-987-6543
Working Hours
We are happy to meet you during our working hours. Please make an appointment.
CSI ITALIA SRL
Galleria San Marco 4
33170 Pordenone
Italy
Telefono +39 0434 28465
Fax + 39 0434 28466
Toll Free
1-800-987-6543
Working Hours
We are happy to meet you during our working hours. Please make an appointment.
All posts by VIS
-
-
28
Mar
2020
In Videos
VIS Concrete Design Program – Slender Columns
Slender columns! They are pretty rare for concrete structures but could be a difficult beast if you run into some. VIS can make their design easier for you. https://youtu.be/Z3kFc6QeSMw
-
04
Feb
2020
In Videos
VIS Concrete Design Program – PMM Strength Design
Note that while for PMM Strength Check the solution is univocal, for Strength Design typically the solutions are infinite in number. https://www.youtube.com/watch?v=tV_Lyxu7qiw Before you watch this video, please first
-
17
Jan
2020
In Videos
VIS Concrete Design Program – PMM Strength Check
SAP2000 and the other analysis programs calculate internal forces at a discreet number of stations along each structural member. One set of internal forces for each load combination. https://www.youtube.com/watch?v=k1GJqhAv_wQ
-
21
Dec
2019
In Videos
VIS Concrete Design Program – Design & Edit
Reinforcement edit and final design follow the preliminary design phase. This is where you refine the reinforcement generated by the Wizard and adjust it to your actual needs. You
-
27
Nov
2019
In Videos
VIS Concrete Design Program – Preliminary Design
VIS design process unfolds through two phases: Preliminary Design and Editing of Reinforcing. Preliminary design is entirely automated. Once that’s done, the user steps in and runs the editing,
-
23
Oct
2019
In Videos
VIS Concrete Design Program – Secondary Members
In this video we will talk about secondary members. According to EC8 Section 4.2.2, Secondary Seismic Members are those not part of the Seismic Action Resisting System of the
-
01
May
2019
In Videos
VIS Concrete Design Program – General Settings
This video shows the GENERAL SETTINGS, which are needed to provide the VIS program with your specific project requirements. Hello there. This video shows the GENERAL SETTINGS, which are
-
16
Apr
2019
In Videos
VIS Concrete Design Program – Wall Definition
Section cutter is a plug-in tool for the definition of wall assemblies. It is necessary only with SAP and CSiBridge. With ETABS, walls are defined directly within the main
-
16
Apr
2019
In Videos
VIS Concrete Design Program – Combinator
Combinator is a plug-in tool for the generation of load combinations sets based on Eurocode provisions. SAP2000 and the other CSi programs allow for the automatic generation of a
- 1
- 2
Viewing page 1 of 2