Galleria San Marco 4 33170 Pordenone Italy Phone +39 0434 28465
We are happy to meet you during our working hours. Please make an appointment.
Galleria San Marco 4 33170 Pordenone Italy Phone +39 0434 28465
We are happy to meet you during our working hours. Please make an appointment.
In Videos
Slender columns! They are pretty rare for concrete structures but could be a difficult beast if you run into some. VIS can make their design easier for you. https://youtu.be/Z3kFc6QeSMw
In Videos
Note that while for PMM Strength Check the solution is univocal, for Strength Design typically the solutions are infinite in number. https://www.youtube.com/watch?v=tV_Lyxu7qiw Before you watch this video, please first
In Videos
SAP2000 and the other analysis programs calculate internal forces at a discreet number of stations along each structural member. One set of internal forces for each load combination. https://www.youtube.com/watch?v=k1GJqhAv_wQ
In Videos
Reinforcement edit and final design follow the preliminary design phase. This is where you refine the reinforcement generated by the Wizard and adjust it to your actual needs. You
In Videos
VIS design process unfolds through two phases: Preliminary Design and Editing of Reinforcing. Preliminary design is entirely automated. Once that’s done, the user steps in and runs the editing,
In Videos
This video shows the GENERAL SETTINGS, which are needed to provide the VIS program with your specific project requirements. Hello there. This video shows the GENERAL SETTINGS, which are
In Videos
Section cutter is a plug-in tool for the definition of wall assemblies. It is necessary only with SAP and CSiBridge. With ETABS, walls are defined directly within the main
In Videos
Combinator is a plug-in tool for the generation of load combinations sets based on Eurocode provisions. SAP2000 and the other CSi programs allow for the automatic generation of a
In Videos
This video shows how to move from an analysis session to a design session. VIS is made up of a collection of separate tools, designed to work within the
In Videos
VIS was developed by CSI Italia, with the intent of expanding SAP2000 and ETABS design capabilities to meet specific Eurocode requirements. Development of VIS started in 2004 and continues
Viewing page 2 of 2